Light fixture installation in Richmond Hill is often part of an LED changeover. The executive houses in Bayview Hill and Westbrook were built with halogen pot lights, glass pendants and dimmers from the incandescent era, and swapping the bulbs alone is what makes them flicker.
I change fixtures and trims and I change the dimmer to match, so the two work together. Chandeliers, vanity lights, kitchen pendants and ceiling fans all get the same treatment on the circuits you already have.
Half the calls I get in Richmond Hill start with buzzing or flickering after someone put LED bulbs into a house full of nineties halogen. Old rotary and slide dimmers were designed for a heavy incandescent load, and a few LED lamps do not draw enough for them to behave. Swapping the dimmer for an LED-rated model on the same circuit fixes it, and matching the trims across a room stops one pot light reading warmer than the rest.
Mon – Sat: 8:00 AM – 8:00 PM
Sunday: By appointment
Before anything comes down I confirm the power is off at the breaker and dead at the terminals, then look at the box itself: how it is fastened, whether a ground is present, and what weight it was built to carry.
If a fan or a heavy chandelier is going up, a fan-rated box or a brace bar between the joists goes in first, fed through the existing hole so your ceiling stays intact and no patching is needed afterwards.
Conductors are stripped clean and joined with correctly sized connectors, the ground lead is fixed to the ground screw in the box, and the wiring is folded back so nothing is pinched when the canopy is drawn up tight.
Power back on, the fixture is run through every setting, dimmers get their low-end trim set with your bulbs in place, a fan is tested at all speeds and balanced if it moves, and the packaging leaves with me.
Height and access drive most of the cost here. A vanity light at chest height is straightforward work. A chandelier over an open stairwell needs staging, careful handling and more time on site. Adding a fan-rated box or a brace bar to a ceiling that never had one takes longer than hanging a fixture where the support is already correct. Quantity helps, since fixtures done in the same visit share a single setup. Fixtures and dimmers can be supplied by you or by me with receipts, and the price is agreed first.
Nothing starts before the price is agreed. Send a photo or two with your request and I can usually quote without a site visit.
Yes, and it is nearly always the dimmer rather than the bulbs. The ones fitted in houses from the nineties expect a big incandescent load, and a handful of LEDs sits below what they can control smoothly. I replace the dimmer with an LED-rated one on the existing circuit and set its low end so the lights come on evenly instead of flickering or humming.
Tell me what needs fixing and get a free, no-obligation quote — I usually reply within one business day.